1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the PCSV connector.
|
3. |
Measure resistance between the PCSV terminals 1 and
2.
|
4. |
Check that the resistance is within the specification.
|
Thermostat. Components and Components
Location
Components
1. Water inlet fitting
2. Thermostat
3. Heater pipe
4. Bypass hose
5. Water temp control assembly
6. Water temperature sensor
7. Gasket
...
Using the Tire Mobility Kit
1. Detach the speed restriction label (0) from the sealant bottle (1), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim.
(Refer to the BD group - " Trunk Lid")
...