Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures / Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the oil temperature sensor connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures

...

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

See also:

Scheduled maintenance service
Follow Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow Maintenance Under Severe Usage ...

Service Adjustment Procedure
Oil level Check A check of ATF level is not normally required during scheduled services. If an oil leak is found, ...

Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2 ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com