Hyundai Accent Manuals

Hyundai Accent: Inspection - Front Strut Assembly. Repair procedures - Front Suspension System - Suspension SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Front Suspension System / Front Strut Assembly. Repair procedures / Inspection

1.
Check the components for damage or deformation.
2.
Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.
3.
If non smooth working or unusual sound during operation, must be exchange the shock absorber.
Disposal
1.
Fully extend the piston rod.
2.
Drill a hole on the (A) section to remove gas from the cylinder.

•
The gas coming out is harmless, but be careful of chips that may fly when drilling.
•
Be sure to wear safety goggles or eye protection.

Disassembly and Reassembly
1. Compress the coil spring with a strut spring compressor. Do not compress the spring more than necessary. 2. Loosen the lock nut. ...

Front Lower Arm. Repair procedures
...

See also:

Repair procedures
Component Replacement After Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Tr ...

ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 7° TPS TPS 1 fault ECM looks at TPS2 ...

Rear Torsion Beam Axle. Repair procedures
Replacement [Disc Type] 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com