Hyundai Accent Manuals

Hyundai Accent: Installation - Engine Control Module (ECM). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Engine Control Module (ECM). Repair procedures / Installation

When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS. (Refer to Body Electrical System - "Immobilizer system")
2) After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer system")
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer system")
1.
Installation is reverse of removal.
ECM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
ECM bracket installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

See also:

Removal
Pressure Side Impact Sensor • Removal of the airbag must be performed according to the ...

Adjustment
Operate the horn, and adjust the tone to a suitable level by turning the adjusting screw. After adjustment, apply a small amo ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com