Hyundai Accent: Installation

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A) after disconnecting the trip switch connector(B). ...

Troubleshooting

Troubleshooting Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) is blown Check for short and ...

See also:

Removal
1. Drain the brake fluid through the bleed plug (A). 2. Remove the clutch release cylinder assembly (C) after removing thd tube (B) ...

Line Pressure Control Solenoid Valve. Specifications
Specifications Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.4 ~ 0.1, 7.6 ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...