Hyundai Accent Manuals

Hyundai Accent: Installation - Repair procedures - Daytime Running Lights - Body Electrical SystemHyundai Accent: Installation

1.
Install the DRL unit.
2.
Install the glove box.

Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the glove box. (Refer to the BD group - "Crash pad") ...

Inspection
1. Check that the light operate according to the following timing chart. 2. If the daytime running light is not operated well, insp ...

See also:

Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...

SS-A Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com