Hyundai Accent: Repair procedures

Schematic Diagrams

Circuit diagram ...

Removal

1. Disconnect the negative(-) battery terminal. 2. Remove the glove box. (Refer to the BD group - "Crash pad") ...

See also:

Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety location. 2.Connect connection hose (9) of the compressor directly to the tire valve. 3.Plug the compressor power c ...

Reassembly
1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...