Hyundai Accent Manuals

Hyundai Accent: Installation - Fuel Tank Pressure Sensor (FTPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Installation is reverse of removal.

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat (Refer to "Seat" in BD gro ...

Injector. Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is c ...

See also:

Notes on the safe use of the Tire Mobility Kit
Park your car at the side of the road so that you can work with the Tire Mobility Kit away from moving traffic. To be sure your vehicle will not move, even when you're on fairly level g ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the se ...

Passenger Airbag (PAB) Module. Description and Operation
Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com