Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Remove the rear seat (Refer to "Seat" in BD group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel tank pressure sensor connector.
|
| 5. |
Remove the fuel tank pressure sensor (A) after releasing
the hooks vertically.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine ...
Removal
Door Mirror Turn Signal Lamp
1.
Remove the mirror (A) from the mirror holder. Be careful not to
damage to the clip.
2.
Remove ...
Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly
inflated or on slippery road surfaces. Tires should be replaced when tread wear
indicators appear. To reduce the ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com