Hyundai Accent: Installation| 1. |
Apply tire soap or lubrication to the top and bottom tire beads.
|
| 2. |
To fit the bottom bead, position the valve at the 5 o’clock position
relative to the head on the tire changing machine.
|
| 3. |
Place the tire on the rim so the bottom bead touches the edge
of the rim after the valve (6 o’clock). Rotate the rim clockwise, and
push down on the tire at the 3 o’clock position to fit bottom bead.
|
| 4. |
After bottom bead is on tire, rotate the rim until the valve is
at the 5 o’clock position relative to the head on the tire changing
machine. Push down on the tire at the 3 o’clock position and rotate
the rim clockwise to fit the top bead.
|
| 5. |
Inflate the tire until both beads seat.
|
RemovalBrake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Electronic stability control (ESC)
The Electronic Stability control (ESC) system is designed to stabilize the vehicle
during cornering maneuvers. ESC checks where you are steering and where the vehicle
is actually going. ESC appl ...
Hands free mic. Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to the BD group - "Roof trim")
...