Hyundai Accent Manuals

Hyundai Accent: Installation - SRS Control Module (SRSCM). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Accent: Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Install the SRSCM with the SRSCM mounting nuts.

Tightening torque:
6.8 ~ 9.2 N.m (0.69 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)

Use new mounting nuts when replacing the SRSCM after a collision.
4.
Connect the SRSCM harness connector.
5.
Install the rear heating joint duct and floor console. (Refer to the Body group - "Console")
6.
Reconnect the battery negative cable.
7.
After installing the SRSCM, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Variant coding
After replacing the SRSCM with a new one, must be performed the “Variant Coding� procedure. 1. On ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS). Schematic Diagrams
Circuit Diagram ...

Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions only for the maintenance items that are easy to perform. As explained earlier in this section, several procedu ...

Description
Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the a ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com