Hyundai Accent Manuals

Hyundai Accent: Removal - SRS Control Module (SRSCM). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Accent: Removal

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console.
(Refer to the Body group - "Console")
4.
Remove the rear heating joint duct (A).

5.
Pull up the lock, of the SRSCM connector, the disconnect the connector (A and B).

6.
Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove the SRSCM.

SRS Control Module (SRSCM). Repair procedures
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

See also:

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

Emergency trunk safety release
Your vehicle is equipped with an emergency trunk release cable located inside the trunk. The lever glows in the dark when the trunk lid is closed. If someone is inadvertently locked in the trunk ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com