Hyundai Accent: Map lamp
Push the lens (1) to turn the map lamp on or off. This light produces a spot beam for convenient use as a map lamp at night or as a personal lamp for the driver and the front passenger.
- DOOR : In the DOOR position, the map lamp and the room lamp come on when any door is opened regardless of the ignition switch position. When doors are unlocked by the transmitter, the map lamp and the room lamp come on for approximately 30 seconds as long as any door is not open. The map lamp and the room lamp goes out gradually after approximately 30 seconds if the door is closed. However, if the ignition switch is ON or all doors are locked, the map lamp and the room lamp will turn off immediately. If a door is opened with the ignition switch in the ACC or LOCK position, the map lamp and the room lamp stay on for about 20 minutes. However, if a door is opened with the ignition switch in the ON position, the map lamp and the room lamp stay on continuously.
- ON : Map lamp and room lamp stay on at all times.
- OFF : The lights turn off even if a door is opened.
❈ When the lamp is turned ON by pressing the lens (1) the lamp does not turn off even if the switch (2) is in the OFF position.
Automatic turn off function
The interior lights automatically turn off approximately 20 minutes after the
ignition switch is turned off. ...
Room lamp
ON (1):
In the ON position, the light stays on at all times.
DOOR (2) :
In the DOOR position, the light comes on when any door is opened regardless of
the ignition switch position.
When doors ...
See also:
Filter replacement
1. Open the glove box and remove the support strap (1).
2. With the glove box open, remove the stoppers by turning them counterclockwise
on both sides.
3. Remove the climate control air filt ...
Knock Sensor (KS). Description
and Operation
Description
Knocking is a phenomenon characterized by undesirable vibration
and noise and can cause engine damage. Knock Sensor (KS) is installed on the
cylinder block and senses engine knoc ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cluster fascia panel (A) after disconnecting the trip
switch connector(B).
...
Hyundai Accent Manuals
