Hyundai Accent: Removal| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column")
|
| 3. |
Disconnect the ignition switch connector (B) and the key switch
connector (A) from under the steering column.
|
| 4. |
If it is necessary to remove the key lock cylinder (A), remove
the key lock cylinder after pushing lock pin with key ACC.
|
Inspection
InstallationCrankshaft Position Sensor
(CKPS). Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS)
and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection
and ignition timing by using ...
Installation
1.
Installation is the reverse of removal.
•
...
Installation
1.
Install the DRL unit.
2.
Install the glove box.
...