Hyundai Accent: Measurement Method| Projected Dimensions |
| 1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
| 2. |
Measure by first adjusting both probes to the same length (A=A').
|
| Measurement Point |
| 1. |
Measurements should be taken at the hole center.
|
GeneralClutch Release Cylinder. Components and Components
Location
Components
1. Union bolt
2. Gasket
3. Tube joint
4. Clutch tube
5. Valve plate
6. Valve spring
7. Bleeder screw
8. Release cylinder
9. Return sprin ...
Removal
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group)
2.
Remove the under cover (A).
...
Components and Components Location
Component Location
1. Rear glass defogger relay (Interior junction box)
2. Rear glass defogger switch (A/C controller)
3. Rear glass defogger
...