Hyundai Accent: Oil Pressure Switch. Repair
procedures
Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch. Repair
procedures
Inspection
| 1. |
Check the continuity between the terminal and the
body with an ohmmeter. If there is no continuity, replace the oil pressure
switch.
|
| 2. |
Check the continuity between the terminal and the
body when the fine wire is pushed. If there is continuity even when
the fine wire is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 49.0kpa (0.5kg/cm²,
7.1psi) is applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm
is broken. Replace it.
|
Installation
1.
Install the oil pan.
(1)
Using a razor blade and gasket scraper, remove
all the old packing material from the gasket surfaces.
...
See also:
Limitation of Active ECO operation
If the following conditions occur while Active ECO is operating, the system operation
is limited even though there is no change in the ECO indicator.
When the coolant temperature is low: The sys ...
Troubleshooting
Troubleshooting
Symptom
Possible cause
Remedy
Hard steering
Improper front wheel alignment
Excessive turning resistance of lower ar ...
Lubricants
Item
Specified lubricant
Quantity
Transaxle fluid
SK ATF SP-Ⅳ, MICHANG ATF SP-Ⅳ,
NOCA ATF SP-Ⅳ, Hyunda ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com