Hyundai Accent: Rear combination light bulb replacement (4 Door)
(1) Stop and tail light
(2) Rear turn signal light
(3) Back-up light
(4) Side marker
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
4. Remove the bulb from the socket by pressing it in and rotating it counterclockwise
until the tabs on the bulb align with the slots in the socket. Pull the bulb out
of the socket.
5. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
6. Install the socket in the assembly by aligning the tabs on the socket with the
slots in the assembly. Push the socket into the assembly and turn the socket clockwise.
7. Install the service cover by putting it into the service hole.
Side repeater light bulb replacement
Type A
1. Remove the light assembly from the vehicle by prying the lens and pulling
the assembly out.
2. Disconnect the bulb electrical connector.
3. Separate the socket and the lens parts by t ...
Rear combination light bulb replacement (5 Door)
(1) Tail light
(2) Rear turn signal light
(3) Back-up light
(4) Stop and tail light
(5) Side marker
1. Open the tailgate.
2. Loosen the light assembly retaining screws with a cross-tip screw ...
See also:
All season tires
HYUNDAI specifies all season tires on some models to provide good performance
for use all year round, including snowy and icy road conditions. All season tires
are identified by ALL SEASON and/or ...
Servicing The Electrical System
1.
Prior to servicing the electrical system, be sure
to turn off the ignition switch and disconnect the battery ground cable.
...
Description and Operation
Description
Ignition timing is controlled by the electronic control ignition
timing system. The standard reference ignition timing data for the engine operating
conditions are pre-programmed ...
Hyundai Accent Manuals
