Hyundai Accent: Installation
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
| 3. |
Place a passenger airbag on the crash pad and tighten the passenger
airbag mounting bolts.
|
| 4. |
Install the crash pad.
(Refer to the Body group - "Crash pad")
|
| 5. |
Tighten the passenger airbag mounting bolts.
|
| 6. |
Connect the passenger airbag harness connector to the SRS main
harness connector.
|
| 7. |
Reinstall the glove box housing.
(Refer to the Body group - "Crash pad")
|
| 8. |
Reconnect the battery negative cable.
|
| 9. |
After installing the passenger airbag (PAB), confirm proper system
operation:
|
Removal
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remove the glove box housing.
...
Side Airbag (SAB) Module. Description
and Operation
Description
The Side Airbags (SAB) are installed inside the front seat and protects
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of side airba ...
See also:
Rail Pressure Sensor (RPS). Specifications
Specification
...
Crankshaft Position Sensor
(CKPS). Description and Operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft
position and is one of the most important sensors of the engine control system.
If there is no CKPS signal input, the eng ...
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wipe ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com