Hyundai Accent: Reassembly| 1. |
After spreading grease on the rack bar gear part (A), install
rack bar (B) in the direction of the arrow.
|
| 2. |
After spreading grease on the pinion gear part, install the pinion
assembly (A).
|
| 3. |
After spreading three bond (Loctite) on the top plug (A) thread,
install the top plug by using the spanner.
|
| 4. |
Install the dust packing & cap (A).
|
| 5. |
Install the support yoke (A).
|
| 6. |
Install the Yoke plug (A) and leaf spring (B).
|
| 7. |
After spreading three bond (Loctite) on the Yoke plug (A) thread,
install the Yoke plug.
|
| 8. |
Adjust Yoke with reference to the “How to adjust Yoke”.(Refer
to "Steering gear box(Adjustment)" in ST group)
|
| 9. |
After fixing the yoke plug, install the rock nut (A).
|
| 10. |
Install the tie-rod & tie-rod end assembly (A). (The left and
right same work)
|
| 11. |
Caulk (A) the rack bar and tie-rod assembly joints. (The left
and right same work)
|
| 12. |
After spreading sealant on the rack hosing and the bellow joints
(A), install the bellows (B) in the direction of the arrow.
|
DisassemblyClosing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks.
To be sure the trunk lid is securely fastened, always check by trying to pull it
up again.
WARNING
The trunk lid s ...
Components
[RH]
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. T ...
Relay Box (Passenger Compartment). Schematic Diagrams
Circuit Diagram
...