Hyundai Accent: Disassembly

Hyundai Accent RB (2010-2018) Service Manual / Steering System / Electric Power Steering / Steering Gear box. Repair procedures / Disassembly

1.	Fix the steering gear box assembly (A) on the vice.

2.	Remove the bellows clip (A) in the direction of the arrow. (The left and right same work.)

3.	Give space to bellows bend (B) by using the ring pliers (A). (The left and right same work)

4.	After making the space to the bellows and tie-rod end contact part by using the (-) driver, remove the bellows (A) in the direction of the arrow.(The left and right same work)

5.	Remove the tie-rod & tie-rod end assembly (A).(The left and right same work)

6.	After fixing the yoke plug (A), remove the rock nut (B).

7.	Remove the yoke plug (A).

8.

Remove the yoke spring (A) and leaf spring (B).

•	Note that there may be urethane pads or back side of O-ring in place of leaf spring.

•	The number of leaf spring can be differs from depending on vehicle.

9.

Remove the support yoke assembly (A) from the inner lack hosing.

•	In case of support yoke assembly (A), the number and availability of O-ring can differ from depending on vehicle.

10.	Remove the dust packing & cap (A).

11.

Remove the top plug (A) by using the spanner.

•	When removing the top plug, top plug is made of aluminum, so be careful to avoid distortion.

12.	Remove the pinion assembly (A).

13.	Remove the rack bar (A) in the direction of the arrow.

Replacement

1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Reassembly

1. After spreading grease on the rack bar gear part (A), install rack bar (B) in the direction of the arrow. ...

See also:

Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth betwe ...

Removal
1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com