Hyundai Accent: Removal
| 1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 2. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
| 3. |
Remove the driver airbag module mounting bolts (2EA).
|
| 4. |
Remove the wiring fixing clip (C), and then release the connector
locking pin to disconnect the driver airbag module connector (B).
|
| 5. |
Remove the steering wheel and steering wheel column shroud.
(Refer to the Steering System group - "Steering Column and Shaft")
|
| 6. |
Disconnect the clock spring connector, then remove the clock spring.
|
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
See also:
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine ...
Change to "winter weight" oil if necessary
In some climates it is recommended that a lower viscosity "winter weight" oil
be used during cold weather. See section 8 for recommendations. If you aren't sure
what weight oil you s ...
Interior light
CAUTION
Do not use the interior lights for extended periods when the engine is
not running. It may cause battery discharge.
WARNING
Do not use the interior lights when driving in the dark. Accide ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com