Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the driver airbag module.
(Refer to the RT group - "DAB and Clock spring")
|
| 3. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
| 4. |
Remove 2 screws on the steering wheel.
|
| 5. |
Remove the steering wheel cover (A) after loosening 4 screws.
|
| 6. |
Remove the remote control switch after loosening 1 screw and disconnecting
the connector.
[RH]
[LH]
|
Inspection
1.
Check the audio remote control switch (A) for resistance between
terminals in each switch position.
Switch
C ...
Installation
1.
Reassemble the steering wheel remote control switch after connecting
the connector.
2.
Reassemble the steering wheel.
...
See also:
To cancel cruise control, do one of the following
Press the brake pedal.
Press the clutch pedal with a manual transaxle.
Shift the shift lever into N (Neutral) with an automatic transaxle
Press the CANCEL switch located on the steering whe ...
Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS
failure.
2.
When ESC or TCS fails, only the failed s ...
PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement
about all part of the passenger seat. (Not included full seat assembly)
1.
Ignition “OFF” ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com