Hyundai Accent Manuals

Hyundai Accent: Removal - Power Door Lock Switch. Repair procedures - Power Door Locks - Body Electrical SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch. Repair procedures / Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
3.
Disconnect the power window switch module connector (A) from the wiring harness.
4.
Remove the power window switch module (A) from the door trim after loosening the mounting screws (5EA).

-
Be careful not to damage door trim panel and door module mounting hooks.

Inspection
Driver Door Lock Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to ...

Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...

See also:

Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...

Removal
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Turn the steering wheel so that the ...

Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com