Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch. Repair procedures / Installation

1.	Install the power window switch module.

2.

Install the door trim panel after reconnecting the relevant connectors

-	Make sure that the power window switch module connectors are plugged properly.

-	Check that the power window switch and door lock switch operate normally.

Removal

1. Disconnect the negative(-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") ...

Power Door Mirrors

...

See also:

Reassembly
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots. 2. Apply grease to the joint boot on the side of the wheel an ...

Removal
1. Remove the front wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Repair procedures
Inspection Front Door Lock Actuator 1. Remove the front door trim. (Refer to the Body group - Front door) 2. Remove the front door ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com