Hyundai Accent: Removal
Head Lamp
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper.
(Refer to the BD group - "Front bumper")
|
| 3. |
Loosening the head lamp mounting bolts (4EA) and disconnect the
head lamp connector(B). Then, remove the head lamp assembly (A).
|
| 4. |
Remove the dust cap(A) and disconnect the connector. Then remove
the head lamp (high / low) bulb(B).
|
| 5. |
Disconnect the connector(A) and remove the turn signal lamp.
|
Installation
1.
Install the head lamp assembly after connecting the connector.
2.
Install the front bumper.
3.
Connect the n ...
See also:
To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch is ...
Using the Tire Mobility Kit
1. Detach the speed restriction label (0) from the sealant bottle (1), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the rear seat (Refer to "Seat" in BD gro ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com