Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the trunk trim.
(Refer to the BD group - " Trunk Lid")
|
| 3. |
Disconnect the connector and remove the high mounted stop lamp
bulb (A).
|
Installation
1.
Install the high mounted stop lamp.
2.
Install the trunk trim.
...
See also:
PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement
about all part of the passenger seat. (Not included full seat assembly)
1.
Ignition “OFF” ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...
Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14
(0.1 ~ 5.5, 1.42 ~ 7.82)
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com