Hyundai Accent: Removal
|
| [Bank 1 / Intake] |
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector
(A).
|
| 3. |
Remove the installation bolt (B), and then remove
the sensor.
|
| [Bank 1 / Exhaust] |
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector
(A).
|
| 3. |
Remove the hanger and the protector.
|
| 4. |
Remove the installation bolt (B), and then remove
the sensor.
|
Inspection
1.
Check the signal waveform of the CMPS and CKPS using
the GDS.
Specification:
Refer to “Wave Form”
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Starter. Components and Components
Location
Components
1. Screw
2. Front bracket
3. Stop ring
4. Stopper
5. Overrun clutch
6. Lever
7. Lever plate
8. Lever packing
9. Magnet switch
10. Arma ...
Master Cylinder. Components and Components Location
Components
1. Reservoir cap
2. Reservoir
3. Grommet
4. Master cylinder assembly
...
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the lower arm for deformation.
3.
Check the all bolts ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com