Hyundai Accent Manuals

Hyundai Accent: Installation - Camshaft Position Sensor (CMPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage.
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Installation is reverse of removal.
Camshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Removal
• DON’T remove the camshaft position sensor while the engine is running or right after engi ...

Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knoc ...

See also:

Starter. Components and Components Location
Components 1. Screw 2. Front bracket 3. Stop ring 4. Stopper 5. Overrun clutch 6. Lever 7. Lever plate 8. Lever packing 9. Magnet switch 10. Arma ...

Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures reco ...

Removal
1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical group - "Battery") ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com