Hyundai Accent Manuals

Hyundai Accent: Removal - Rail Pressure Sensor (RPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line� in this group).
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line� work.
3.
Remove the intake manifold (Refer to “Intake And Exhaust System� in EM group).
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.


Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
• Install the component with the specified torques. • ...

See also:

Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Description and Operation
Description Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive ...

Using the Tire Mobility Kit
1. Detach the speed restriction label (0) from the sealant bottle (1), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too ...

Removal
1. Turn ignition switch OFF. 2. Disconnect the brake fluid level switch connector (A) from the reservoir. 3. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com