Hyundai Accent: Removal
| 1. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
|
| 2. |
Remove the rear seat [LH] (Refer to “Seat” in BD
group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel pump connector (A).
|
| 5. |
Disconnect the fuel feed tube quick connector (B).
|
| 6. |
Disconnect the fuel tank pressure sensor connector
(C).
|
| 7. |
Disconnect the vapor tube (D).
|
| 8. |
Lift the vehicle and support the fuel tank with a
jack.
|
| 9. |
Remove the center muffler assembly (Refer to “Intake
And Exhaust System” in EM group).
|
| 10. |
Disconnect the fuel filler hose (A) and the vapor
hose (B).
|
| 11. |
Remove the parking brake line installation bolt (A).
|
| 12. |
Remove the fuel tank from the vehicle after removing
the fuel tank band (A).
|
Installation
1.
Installation is reverse of removal.
Fuel tank band
installation nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~
39.8 lb-ft ...
See also:
Installation
1.
Installation is the reverse of removal.
If the oil seal on the transaxle case side is damaged a ...
Installation
Rear Disc Brake Type
1.
Install the parking brake cable.
2.
Install the parking brake cable (A), and then install the clip
(B ...
Inspection
Multifunction Switch (Lighting)
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lighting switch of the multi-function switc ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com