Hyundai Accent: Removal
| 1. |
Open the fuel filler door, and then remove the filler-neck
assembly mounting screws (A).
|
| 2. |
Disconnect the fuel filler hose (A) and tue vapor
hose (B).
|
| 3. |
Remove the filler-neck assembly from the vehicle
after removing the bracket mounting bolt (A).
|
Installation
1.
Installation is reverse of removal.
Filler-neck assembly
bracket installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...
See also:
Fuel Pressure Control Valve. Repair procedures
Inspection
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the fuel pressure regulator valve ...
Closing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks.
To be sure the trunk lid is securely fastened, always check by trying to pull it
up again.
WARNING
The trunk lid s ...
Removal
1.
Disconnect the battery negative cable and wait for at least 3
minutes before beginning work.
2.
Remove the roof trim.
(Refer to ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com