Hyundai Accent: Removal
In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
|
| 3. |
Remove the intake manifold (Refer to "Intake And
Exhaust System" in EM group).
|
| 4. |
Disconnect the injector connectors (A) and the rail
pressure sensor connector (B).
|
| 5. |
Remove the high pressure fuel pipe (C).
|
| 6. |
Remove the engine oil gauge.
|
| 7. |
Remove the installation bolt (D), and then remove
the delivery pipe and injector assembly from the engine.
|
Installation
•
Do not use already used injector fixing clip
again.
...
See also:
Reporting safety defects
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform the National Highway Traffic
Safety Administration (NHTSA) in ...
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
Steering Gear box. Components and
Components Location
Components
1. Tie-rod end
2. Lock nut
3. Bellows clip
4. Bellows
5. Tie rod
6. Rack bar
7. Dust packing
8. Dust cap
9. Oil seal
10. Pinion plug
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com