Hyundai Accent: Removal
| 1. |
Remove the transaxle assembly. (Refer to "Manual
transaxle system" in MT group)
|
| 2. |
Remove the clutch cover bolts. Be careful not to
be bent ortwist bolts. Loosen bolts in diagonal directions.
|
Inspection
1.
Inspect diaphragm spring wear which is in contact
with a concentric slave cylinder bearing.
2.
Check the clutch cover and disc surface f ...
See also:
Repair procedures
Inspection
Manual Transaxle Oil Inspection
1.
Park the vehicle on a level ground and stop the engine.
2.
Retighten the oil f ...
Replacement
Standard values, such as torques and certain adjustments,
must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced
with new ones ...
Thermostat. Components and Components
Location
Components
1. Water inlet fitting
2. Thermostat
3. Heater pipe
4. Bypass hose
5. Water temp control assembly
6. Water temperature sensor
7. Gasket
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com