Hyundai Accent Manuals

Hyundai Accent: Removal - Clutch Pedal. Repair procedures - Clutch System - Clutch SystemHyundai Accent: Removal

•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1.
Disconnect the ignition lock switch connector (A) and clutch switch (B).

2.
Disconnect the push rod from the clutch pedal by removing the snap pin (A) and washer.

3.
Remove the clutch pedal mounting nuts (A-3ea, B-1ea).

Tightening torque:
(A) 12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
(B) 18.6 ~ 23.5 .Nm (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

4.
Remove the clutch pedal assembly.


Inspection
Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measu ...

Installation
1. Installation is the reverse of removal. ...

See also:

Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open. Place your sunglasses in the compartment door with the lenses facing out. Push to close. WARNING Do not keep ob ...

Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct si ...

Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form� ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com