Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Removal

•	Removal of the airbag must be performed according to the precautions/ procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front bumper. (Refer to the Body group - "Front bumper")

3.	Remove the washer reservoir. (Refer to the Body Electrical group - "Washer motor") [Right side only]

4.	Remove the front impact sensor mounting bolt (A).

5.	Disconnect the front impact sensor connector (B).

6.	Remove the front impact sensor.

Front Impact Sensor (FIS). Repair procedures

...

Installation

• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

See also:

Injector. Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Exterior care
Exterior general caution It is very important to follow the label directions when using any chemical cleaner or polish. Read all warning and caution statements that appear on the label. Finish mai ...

Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com