Hyundai Accent: Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Remove the floor console.
(Refer to the Body group - "Console")
|
| 4. |
Remove the rear heating joint duct (A).
|
| 5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A and B).
|
| 6. |
Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove
the SRSCM.
|
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
See also:
If engine doesn't turn over or turns over slowly
1. If your vehicle has an automatic transaxle, be sure the shift lever is in
N (Neutral) or P (Park) and the emergency brake is set.
2. Check the battery connections to be sure they are clean and t ...
Specifications
Specification
Item
Bulb Watt (W)
Bulb Type
Front
Head lamp (High)
60
HB2 LL
Head lamp (Low)
...
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com