Hyundai Accent: Installation
| 1. |
Installation is the reverse of removal.
|
| 2. |
Use a SST (09581-11000) when installing the brake caliper assembly.
|
| 3. |
After installation, bleed the brake system. (Refer to Brake system
bleeding)
|
Inspection
Front Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Rear Disc Brake. Components and Components Location
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS). Specifications
Specifications
Direct control VFS[35R/C]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.5 ~ 0.1, 7.82 ~ 1.42 ...
If engine turns over normally but does not start
1. Check fuel level.
2. With the ignition switch in the LOCK position, check all connectors at ignition
coils and spark plugs. Reconnect any that may be disconnected or loose.
3. If the engine sti ...
Changing the engine oil and filter
Have engine oil and filter changed by an authorized HYUNDAI dealer according
to the Maintenance Schedule at the beginning of this section.
CALIFORNIA PROPOSITION 65 WARNING
Engine oil contains c ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com