Hyundai Accent Manuals

Hyundai Accent: Removal and Installation - Starter. Repair procedures - Starting System - Engine Electrical SystemHyundai Accent: Removal and Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Electrical System / Starting System / Starter. Repair procedures / Removal and Installation

1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the air duct and air cleaner assembly. (Refer to EM group)
3.
Disconnect the starter cable (B) from the B terminal on the solenoid then disconnect the connector (A) from the S terminal.
4.
Remove the 2 bolts holding the starter, then remove the starter (A).
Tighting torque :
42.2 ~ 53.9 Nm (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)

5.
Installation is the reverse of removal.
6.
Connect the battery negative terminal last.

Starter. Repair procedures
...

Disassembly
1. Disconnect the M-terminal (A) on the magnet switchassembly. 2. After loosening the 2 screws (A), detach the magnetswitch assembl ...

See also:

Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

Components and Components Location
Components Location 1. Overdrive clutch (OD/C) 2. One way clutch (OWC) 3. Low & Reverse brake (LR/B) 4. Underdrive brake (UD/B) 5. 26 brake (26/B) 6. 35R ...

Components and Components Location
Components 1. Steering wheel 2. Steering column & EPS unit assembly 3. Universal joint assembly 4. Steering gear box ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com