1. |
Measure the tread depth of the tires.
|
2. |
If the remaining tread depth (A) is less than the limit, replace
the tire.
|
Checking For Pull And Wander |
1. |
Rotate the front right and front left tires, and perform a road
test in order to confirm vehicle stability.
|
2. |
If the steering pulls to the opposite side, rotate the front and
rear tires, and perform a road test again.
|
3. |
If the steering continues to pull to one side, rotate the front
right and left tires again, and perform a road test.
|
4. |
If the steering continues to pull to the opposite side, replace
the front wheels with new ones.
|
Removal
1.
Drain the brake fluid through the bleed plug (A).
2.
Remove the clutch release cylinder assembly (C) after
removing thd tube (B) ...
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wipe ...
Yaw-rate and G Sensor. Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the front seat (LH) assembly.
(Refer ...