Symptoms
|
Possible Causes
|
Remedy
|
Coolant leakage
|
| •
|
From the bleed hole of the water pump
|
|
Visually check
|
| •
|
Check leaks after about ten-minute warming
up.
|
|
| •
|
If coolant still leaks, replace a water pump.
|
|
| •
|
If leakage stops, reuse the water pump (Do
not replace the pump with a new one).
|
|
| •
|
From gaskets or bolts
|
|
| •
|
Check the tightening of the water pump mounting
bolts.
|
|
| •
|
Retighten the mounting bolts.
|
|
| •
|
Check damage of gaskets or inflow of dust.
|
|
| •
|
Replace the gasket and clean dust off.
|
|
| •
|
From outer surface of water pump
|
|
| •
|
Check the material or any cracks of the water
pump.
|
|
| •
|
Poor material. If any crack found, replace
the water pump.
|
|
Noise
|
| •
|
From mechanical seals
|
| •
|
Impeller interference
|
|
Inspection with a stethoscope
|
| •
|
After starting the engine, check noise with
a stethoscope.
|
|
| •
|
If there is no noise, reuse the water pump(do
not replace it).
|
|
| •
|
If there is any noise from the water pump,
remove the drive belt and recheck.
|
|
Inspection after removing a drive belt
|
| •
|
After removing a water pump and a drive belt,
check noise again.
|
|
| •
|
If there is noise, reuse the water pump.
Check other drive line parts.
|
|
| •
|
If there is no noise, replace the water pump
with a new one.
|
|
Inspection after removing a water pump
|
| •
|
After removing a water pump and a drive belt,
check noise again.
|
|
| •
|
If there is any interference between them,
replace the water pump with a new one.
|
|
Overheating
|
|
Loosened impeller
|
| •
|
Corrosion of the impeller wing
|
|
| •
|
Check engine coolant.
|
| •
|
Poor coolant quality / Maintenance check
|
|
| •
|
Impeller seperation from the shaft
|
|
| •
|
Replace the water pump.
|
|
1.
Check each part for cracks, damage or wear, and replace
the coolant pump assembly if necessary.
2.
Check the bearing for damage, abnorma ...
See also:
Components of the Tire Mobility Kit
0. Speed restriction label
1. Sealant bottle and label with speed restriction
2. Filling hose from sealant bottle to wheel
3. Connectors and cable for the power outlet direct connection
4. Holde ...
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mu ...
Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first
turn the steering wheel right and left to clear the area around your front wheels.
Then, shift back and forth betwe ...
Hyundai Accent: Water pump. Troubleshooting
Inspection
Radiator. Components and Components
Location