Removal
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the front seat (LH) assembly.
(Refer to the Body group - "Seat")
|
3. |
Disconnect the yaw rate & lateral G sensor connector (A).
|
4. |
Remove the mounting nuts (B).
|
5. |
Installation is the reverse of removal.
|
General Safety Information and
Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, ...
Replacement
[Disc Type]
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and ...
Front Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the front wheel alignment, always positio ...