Hyundai Accent Manuals

Hyundai Accent: PODS-F Zeroing procedure - Passive Occupant Detection System (PODS-F). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: PODS-F Zeroing procedure

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Passive Occupant Detection System (PODS-F). Repair procedures / PODS-F Zeroing procedure

You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly)
1.
Ignition “OFF”, connect GDS.
2.
Ignition “ON” & Engine “OFF”, select Airbag system and “PODS-F Reset” mode.
3.
The GDS will show the two PODS-F Zeroing function steps.
(1)
Erase PODS-F diagnostic codes.
(2)
PODS-F initialization.

This step must be done PODS-F re-zero, when the front passenger seat is empty.
4.
The PODS-F initialization procedure will be performed.

Erase the SRSCM diagnostic codes after completing the PODS-F zeroing.
In case of zeroing failure
-
Code 01 : Requestor ID out of range.
-
Code 02 : ECU faults.
-
Code 03 : ODS sensor short to ground.
-
Code 04 : Open between ODS ECU and mat.
-
Code 05 : ODS ECU has not been trimmed.
-
Code 06 : Configuration disabled in ECU calibration.
-
Code 07 : Configuration value out of range.
-
Code 08 : Used in zero Request response only.
-
Code 09 : Algo enabled this ignition cycles.
-
Code 0A : Upper offset value created during the zero process.
-
Code 0B : Lower offset value created during the zero process.
-
Code 0C : Voltage diagnostic
-
Code 0D : The delta of QX_Freq_Low and QX_Freq_High must remain low.
-
Code 0E : Temperature is above O deg C during the zero process.
-
Code 0F : Re-read QX Final compare delta limit. (zero verify)

Installation
PODS-F ECU 1. Install the PODS-F ECU equipped seat track assembly. (Refer to the Body group - "Seat") 2. Install the ...

Schematic Diagrams
...

See also:

Installation
• Install the component with the specified torques. • ...

Cleaning
1. Make sure the ignition switch and all accessories are in the OFF position. 2. Disconnect the battery cables (negative first). ...

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com