Hyundai Accent Manuals

Hyundai Accent: Installation - Curtain Airbag (CAB) Module. Repair procedures - Airbag Module - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Airbag Module / Curtain Airbag (CAB) Module. Repair procedures / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to the Body group - "Interior")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. (Refer to ...

Airbag Module Disposal. Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbag ...

See also:

Seat Heater. Repair procedures
Inspection Driver seat and Passenger seat 1. Check for continuity and measure the resistance between terminals. [Cushion] ...

Anchor Pretensioner (APT). Description and Operation
Description Front anchor pretensioner operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver se ...

Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com