Hyundai Accent Manuals

Hyundai Accent: Seat Heater. Repair procedures - Seat Electrical - Body Electrical SystemHyundai Accent: Seat Heater. Repair procedures

Inspection

Driver seat and Passenger seat
1.
Check for continuity and measure the resistance between terminals.
[Cushion]

PIN
No.
Description
PIN
No.
Description
3
Heater (+)
5
NTC -
4
NTC +
6
GND


Average Max. temperature
- Cushion : HIGH : 42 ± 2°C / LOW : 39 ± 2°C
- Back : HIGH : 52 ± 2°C / LOW : 46 ± 2°C

2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value (Fabric / Leather)
- Cushion : 1.54Ω ± 10%
- Back : 1.23Ω ± 10%
- Set : 2.77Ω ± 10%


Seat Heater. Components and Components Location
Components ...

Seat Heater Switch. Schematic Diagrams
Schematic Diagram ...

See also:

Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant level at least once ...

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...

Removal and Installation
1. Disconnect the battery negative terminal. Tightening torque (-) terminal : 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4l ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com