Hyundai Accent Manuals

Hyundai Accent: Installation - Seat Belt Pretensioner (BPT). Repair procedures - Seat Belt Pretensioner - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT). Repair procedures / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the seat belt pretensioner with mounting bolts (B, C).
Tightening torque [Bolt B]:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner (BPT) connector (A).
5.
Install the upper anchor bolts.
Tightening torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the following parts.
(Refer to the Body group - "Interior trim")
A.
Center pillar trim
B.
Door scuff trim
7.
Insert the seat belt to the anchor pretensioner (A).

Make sure the lock pin is connected in properly.
8.
Reconnect the battery negative cable.
9.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the seat belt after pushing ...

Anchor Pretensioner (APT). Description and Operation
Description Front anchor pretensioner operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver se ...

See also:

Using a child restraint system
For small children and babies, the use of a child seat or infant seat is required. This child seat or infant seat should be of appropriate size for the child and should be installed in accordanc ...

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition k ...

Canister Close Valve (CCV). Description and Operation
Description Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmo ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com