1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
2. |
Remove the seat belt after pushing the lock pin (A).
|
3. |
Remove the following parts.
(Refer to the Body group - "Interior trim")
|
4. |
Remove the upper anchor bolt.
|
5. |
Disconnect the seat belt pretensioner connector (A).
|
6. |
Loosen the seat belt pretensioner mounting bolts (B,C) and remove
the seat belt pretensioner.
|
Components and Components Location
Components Location
1. PCV valve
2. Canister
3. Purge control solenoid valve (PCSV)
4. Fuel tank pressure sensor (FTPS)
5. Canister close valve (CCV)
6. Fuel ...
Crankshaft Position Sensor
(CKPS). Description and Operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft
position and is one of the most important sensors of the engine control system.
If there is no CKPS signal input, the eng ...
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...