Hyundai Accent Manuals

Hyundai Accent: Installation - Anchor Pretensioner (APT). Repair procedures - Seat Belt Pretensioner - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Seat Belt Pretensioner / Anchor Pretensioner (APT). Repair procedures / Installation

1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
3.
Install the anchor pretensioner with mounting bolt.
Tightening torque :
39.2 ~ 53.9 N.m(4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Connect the anchor pretensioner connector.
5.
Install the following parts.
(Refer to the Body group - "Interior trim")
A.
Center pillar trim
B.
Door scuff trim
6.
Insert the seat belt to the anchor pretensioner (A).

Make sure the lock pin is connected in properly.
7.
Reconnect the battery negative cable.
8.
After installing the anchor pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the seat belt after pushing ...

Brake System
...

See also:

Installation
Be sure to install the harness wires so they will not pinch or interfere with other parts. 1. ...

Floor mat anchor
When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING The floor mat must be ...

Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left on the tire. Replace the tire when ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com