Hyundai Accent Manuals

Hyundai Accent: Removal - Brake Pedal. Repair procedures - Brake System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Brake Pedal. Repair procedures / Removal

1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
3.
Disconnect the stop lamp switch connector (A).
4.
Remove the shift lock cable (B) after removing the snap pin and the clip.
5.
Remove the BCM.
(Refer to the Body Electrical group - "BCM".)
6.
Remove the mounting bracket bolts (B).
Tightening torque:
19.6 ~ 25.5 N.m (2.0 ~ 2.6 kgf.m, 14.5 ~ 18.8 lb-ft)

7.
Remove the snap pin (A) and clevis pin (B).
8.
Remove the brake pedal member assembly mounting nuts (A) and then remove the brake pedal assembly.
Tightening torque:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)


Brake Pedal. Repair procedures
...

Inspection
1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal retur ...

See also:

Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in ...

Snow tires
If you equip your car with snow tires, they should be the same size and have the same load capacity as the original tires. Snow tires should be installed on all four wheels; otherwise, poor handli ...

Dimensions Projected
1. These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body ...

Hyundai Accent Manuals


В© 2011-2025 Copyright www.hamanual.com