Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Brake Pedal. Repair procedures / Inspection

1.	Check the bushing for wear.

2.	Check the brake pedal for bending or twisting.

3.	Check the brake pedal return spring for damage.

4.

Check the stop lamp switch.

(1)	Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.

(2)	The stop lamp switch is in good condition if there is no continuity when plunger (A) is pushed.

Removal

1. Turn ignition switch OFF. 2. Remove the crash pad lower panel. (Refer to the Body group - "Crash pad") ...

Installation

1. Installation is the reverse of removal. • ...

See also:

SS-A Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) ...

Sunroof. Components and Components Location
Components 1. Sunroof frame assembly 2. Motor assembly 3. Glass assembly 4. Guide assembly 5. Drip rail assembly 6. Drip link 7. Sunshade assembly 8. Defle ...

Line Pressure Control Solenoid Valve. Specifications
Specifications Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.4 ~ 0.1, 7.6 ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com