Hyundai Accent: Adjustment
| Parking Brake Lever Stroke Adjustment |
| 1. |
Remove the floor console.
(Refer to Body group - "Floor console".)
|
| 2. |
Remove the floor console rear mounting bracket (A).
|
| 3. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
|
| 4. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
| 5. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
| 6. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
| 7. |
Install the floor console rear mounting bracket.
|
| 8. |
Install thd floor console. (Refer to the Body group - "Floor console")
|
| Parking Brake Shoe Clearance Adjustment |
Rear Drum Brake Type
| 1. |
Depress the brake pedal several times to set the self-adjusting
brake.
|
Rear Disc Brake Type
Re-setting of the parking brake is necessary after overhauling
the caliper body, or if the brake calipers, housing, parking brake cable
or brake discs have been changed.
|
| 1. |
Remove the floor console to reach the adjusting nut.
|
| 2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
| 3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
| 4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
| 5. |
Refit the floor console.
|
| 6. |
Parking brake lever in the car must be in fully loosened position.
|
| 7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
| 8. |
Check the wheels of their free operation.
|
| 9. |
Test drive.
|
Installation
Rear Disc Brake Type
1.
Install the parking brake cable.
2.
Install the parking brake cable (A), and then install the clip
(B ...
See also:
Warnings and indicators
All warning lights are checked by turning the ignition switch ON (do not start
the engine). Any light that does not illuminate should be checked by an authorized
HYUNDAI dealer.
After starting th ...
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that
may cau ...
Description and Operation
Description
EPS (Electric power steering, Column assist type) system uses an electric
motor to assist the steering force and it is an engine operation independent
steering system.
EPS ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com